Now on to something more practical, some piano stools. I am making 2 stools each slightly different , one without an armrest and a fabric top, the other with arm rests and a solid top with a fabric insert.
Note: You can see a full thread on this build under the projects tab.
I am hoping to use the left over to start on a wall hung cabinet for handtools in a future project.
I picked a couple of similarly colored boards and rough cut them to length and cleaned them up.
There is quite a variance in color between boards, depending on how the finished piece looks I’ll apply some stain to even things out when finishing the pieces.
After letting them sit for a few days I trimmed the boards to final dimensions and cut out the x8 leg blanks on the tablesaw.
All the leg tapers were marked on the legs for easy reference, technically if your cutting the boards on a taper jig you dont need all the marks but they come in handy when finishing with a handplane or keeping an eye out for mistakes.
Basic taper jig I whipped up using some scrap 12mm MDF and a few jig fittings.
I bought 10 toggle clamps on eBay a while back and I just re-use them on jigs when needed, turned out very handy and they only take a minute to screw in anywhere they are needed.
Tapers were cleaned up with a handplane and legs milled to final dimensions. The legs developed a nice shine after handplaning. I think I’ll either round over the edges or chamfer them to soften those corners, still unsure what to do just yet. I’ll wait till I do a dry fit before making a decision.
Joints being cut ready for glue up using a domino.